Quality ACREL ASCB Circuit Breaker,smart MCB,Smart Circuit Breaker Supplier

Three Phase Smart Circuit Breaker ASCB1-63

Home > Products > Power Monitoring Controlling > Smart Circuit Breaker > Three Phase Smart Circuit Breaker ASCB1-63

Three Phase Smart Circuit Breaker ASCB1-63

● Rated voltage: 230V (1P/2P), 400V (3P/4P)

● Rated current: 16A，32A，63A

● Rated short-circuit breaking capacity: 6000A

● Real-time monitoring of electric parameters such as voltage, current, power, electrical energy and temperature

● Overvoltage, undervoltage, overload, short circuit, overcurrent and overtemperature protection

● With local manual push rod, local electric control, local lock, remote control, timing control and so on

● RS485 (Modbus-RTU) standard, with Ethernet and 4G optional

Download Request a quote

product detail
MCB PARAMETER
Gateway PARAMETER

General

ASCB1 series intelligent miniature circuit breakers (hereinafter referred to as intelligent miniature circuit breakers) are used in low-voltage terminal power distribution networks in industrial, commercial, civil buildings and infrastructures in indoor buildings and similar places.

The intelligent miniature circuit breaker is used in conjunction with the intelligent gateway to conduct real-time monitoring of the key electrical parameters of the power line, such as voltage, current,power, temperature, leakage, energy consumption, fault location and other functions etc.

This series of products can choose single pole, 2 pole, 3 pole and 4 pole.

Dimension

Installation Method

1) The device is suitable for standard 35mm rail type installation. When installing, just clip the device into the rail and fix it with a buckle .

2) According to the actual power distribution management and line laying design requirements, select and use IoT modules and electrical boxes that meet the needs.

The specifications of the box are assembled and installed in the order of the modules shown in the figure, and each module is connected by a special 8PIN data cable made by the manufacturer.

3) The circuit breaker should be installed vertically. When the handle is in “/OFF”, the contacts are disconnected. When the handle moves upward, the contacts move in the closing direction;

4) See Table 5 for the nominal cross-sectional area of the connecting copper wire that matches the rated current of the circuit breaker.

5) During installation, please tighten the copper wire with the torque specified in Table 5. After installation, check whether the copper wire is firmly connected by shaking the wire, and then tighten the copper wire with the specified torque again. Figure 5 is an example of the installation and wiring of the smart miniature circuit breaker, for reference only.

Wiring

Typical Connection

Photos on Site